新しい会話を開始

未解決

M

11 メッセージ

518

2022年11月17日 06:00

iDRAC9 Firmware 6.00.30.00 の日本語キーボード操作について

iDRAC9 Firmware 6.00以降”Only eHTML5 plug-in type supported for accessing Virtual Console”とのことですが

日本語キーボードの全角/半角ボタン使えません。

何か回避方法ありませんか?

Firmware 5.xxへダウングレードとなりますでしょうか。

Moderator

 • 

6.5K メッセージ

2022年11月17日 21:00

moriakiさん
月並みかもですがこちらのトラブルシュートをしてみるのはどうでしょうか。

Dell EMC Knowledge Article 000185549 : iDRAC Virtual Console Troubleshooting
Scenario 4: Keyboard/Mouse redirection is failing
Troubleshooting Step 1 – iDRAC Configuration
• In the iDRAC user interface, under Configuration > Virtual Console, ensure Keyboard/Mouse Attach State is set to Auto-Attach
• In some cases switch it off then back on again to regain functionality.
• Does keyboard/mouse redirection work during POST? If yes, then we're talking an operating system issue, most likely driver related.
• Does a physical keyboard/mouse work? If no it's a hardware issue.
• If a physical keyboard works, but Virtual Console keyboard/mouse redirection does not work in POST or operating system, run racadm racresetcfg to rebuild it from scratch


またリリースノートには以下の記述もあるのでこれも参考にできるかもしれないですよね。(VirtualKeybordの全角/半角ボタンが使えないというのであればですが)

iDRAC9 Version 6.00.02.00 Release Notes

Page 14 英語以外の言語の場合Virtual Keyboardが使えない場合がある・・・(次のリリースで修正予定)
Table 52. Few Virtual Keyboard keys not working for other languages
Description Some keys or key combination may not provide the correct output for languages other than English.
Workaround Use the physical keyboard or Windows On-Screen Keyboard.

11 メッセージ

2022年11月17日 22:00

VirtualKeyboadでも確認しましたが、そもそも全角/半角ボタンがないですね。

Version5系にダウングレードして使用しようと思います。

001.png

イベントは見つかりませんでした!

Top